Even though we use the best quality control boards we can get made in the USA, we also go through and hand tune every controller board with each motor. There are slight variations in any controller board, and there are slight variations in any motor. What we do is we go through with every single machine and we hand tune those controller boards with that particular motor. If you were to buy a hundred BATA machines, you're going to get exactly the same performance out of each one of those machines because everyone is hand-tuned, hand-tuned to a specific rpm, and hand-tuned to a specific performance.
Leave a comment
All comments are moderated before being published.
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.